EXTRAFLAME LP30 PDF
The Extraflame boiler is a great heating solution developed from the most All Extraflame products are built in compliance with the following Directives: 89/ . ‘Pellet refill pipes on store’. ‘Feed auger system routed outside to wooden clad 3 tonne storage’. ‘Extraflame LP30 plumbed to heat house and swimming pool’. Extraflame LP30 Manual Online: Alarms Table. ALARMS TABLE ALARMS Reason Indicates the presence of an alarm. Flue gas motor fault Flue gas probe fault.
|Published (Last):||3 November 2004|
|PDF File Size:||1.76 Mb|
|ePub File Size:||19.29 Mb|
|Price:||Free* [*Free Regsitration Required]|
Opening hours Monday – Friday: Adjusting power setting Set the operating power from 1 to 5.
WELDED GRATE-BRAZIER UNITLP30 Nordica Extraflame
All particulars subject to normal wear are not covered by warranty: VRS5W instruction manual Version 1. LK Electric Boiler, kw is delivered.
EN Thermal and fluid dynamic calculation methods. UHM V 50Hz W Safety Precautions To reduce the risk of personal injury or damage to property, basic safety precautions must be observed including the More information.
Sunday prg3 off set prg3 start – prg4 extraflamr Connection to the extraflzme evacuation system Please enter up to 7 characters for the postcode. Buy it now – Add to Watch list Added to your Watch list. Air the room well several times. The smoke channel must have constant section.
Pellet boilers – La Nordica Extraflame
Please carefully read this instruction before using the product. The holes at the bottom must be completely free to guarantee correct combustion. Take a look at our Returning an item help page for more details. No current during the ignition phase. These features highlight their valuable nature. As previously described, when installing, all national, regional, provincial and town council Standards in force provided by the country in which the appliance has been installed must be complied with.
Installation and safety devices The installation, relative system connections, commissioning and inspection of correct functioning must be carried out perfectly, in full compliance with Standards in force, national, regional and municipal, as well as these instructions.
Take the boiler to off conditions using key 1 and repeat the procedure described in the “Ignition” chapter.
Actual product may differ slightly to that depicted.
It is therefore necessary to adopt the minimum heights indicated in the figure layouts below. To make this website work, we log user data and share it with processors. If the water temperature drops, exceeding the pre-set parameters, the machine will switch back on.
Q is the useful outlet power to the generator water expressed in kilowatt. The unit produces nitrogen by separating. Do not discard this manual. This item will be sent through the Global Shipping Programme and includes international tracking. If coverings in combustion material or sensitive to heat exist in the space above the generator, an insulating and non combustible protection diaphragm must be inserted.
The smoke channel must allow the recovery of soot or be brushable. The permanent openings in the adjacent room must comply with the above-described requisites.
Please enter a number less than or equal to 1. Notes on these instructions The connection piping of the safety valve to the heat generator must not be traceable and must not present, in any point, a The designer must check that the maximum pressure existing in every point of the system, does not exceed the maximum extrwflame pressure of its every component.
Contact the seller – opens in a new window or tab and request post to your location.
The tank must be full of pellets The combustion chamber must be clean The burn pot must be completely free and clean Check the hermetic closure of the fire door and the ash drawer Check that the power supply cable is connected correctly The bipolar switch in the rear right part must be positioned on 1.
The purchaser forwards theinspection report and warranty validation copy 2 filled-in completely, within 8 days from the date of validation of the warranty.
Extraflame LP30, vacuum feed system and 3 tonne hopper
The smoke channels must not cross rooms where the installation of the combustion appliances is not allowed. No compensation will be paid for the time the product is inefficient. For the heat generator appliances equipped with electric fan for expelling combustion products, the instructions below must be followed: The solution used for this purpose is described in the design.
The appliance controls the water temperature through a probe installed as per standard, which modulates machine power until the set point set is reached.
The appliance is used as prescribed in the instructions manual provided with all products. The product has been designed and realised to work with closed vessel systems. See the images for feeding pellets. Amongst the inconveniences caused by bad quality feeding water, the most frequent is the scaling of the heat exchange surfaces.
EXTRAFLAME EN | Τζάκια Μισαηλίδη
Generally, the closed vessel system has one of the following expansion vessels: Elements in combustible or inflammable material like wooden furniture, curtains, etc. The problems correlated to the amount of exhraflame can be divided into categories: These must not escape from the terminal board in any situation, thus preventing possible contact with the live parts of the wire. Appliances for cooking food and relative hoods without extractor are only allowed in kitchens.
For diameter of outlet connection it is intended the minimum internal diameter on the valve outlet upstream of the eventual internal threading. Pellet feed calibration inadequate. The direct discharge towards closed spaces is forbidden, even with clear sky.